Best Way To Cut A Hole In Vinyl Siding

You can also use tin snips to make crosscuts.

Best way to cut a hole in vinyl siding.

A hole saw tin snips etc will slice right through it. Bend the strip of siding along the cut and snap the. Score along the straightedge with a utility knife. A utility knife is the best tool you can use if you want to cut a long horizontal cut throughout a strip of vinyl siding.

The pilot bit on the hole saw was set to be long enough to punch through the siding as well. As you re cutting the siding avoid closing the blades on the tin snips all the way so you get a cleaner cut. Place a strip of siding face up on the work table. The method which we are going to use to cut vinyl siding is the score and snap method.

Cutting the vinyl siding is easy. Holes an inch or two across or long narrow holes that still appear patchable require removing the damaged piece of vinyl to fix it. Wear safety goggles while you re cutting the siding. Place a straightedge lengthwise on the strip to mark where you plan to cut it.

That said the hole is the least of your effort. When we cut with a circular saw we often install the blade backwards to minimize ripping and tearing of the vinyl. This method is best for cutting a lot of short or long vertical cuts since the circular saw will create clean incisions relatively quickly. When making longitudinal cuts score with a knife and break along the score line.

Set aside the straightedge. Cover the hole from the back side with foil tape then put the siding back where it belongs. Using a circular saw is the first method that you can use to cut vinyl siding. Keep cutting until you get all the way across the vinyl siding.

Cut along the marked line using tin snips. Not just any circular saw blade will do. Make crosscuts on vinyl siding using a circular saw but you should install a vinyl cutting blade to minimize chip out. A siding zip tool pops the piece off from the bottom edge.

Cutting through an exterior wall can be difficult in that the vinyl siding can easily chip or shatter. Use tin snips or a rotary tool to make curved cuts.